NEW SITE SALE! Use the discount code INTRO21 at checkout for 10% your entire order! 2021/1/29 17:00:00
×
Clamp the drill in a vice using a rag so as not to damage the covers.  Fully open the chuck and remove T40 screw on the left hand thread.  Tighten chuck jaws onto the allen key and remove chuck anti clockwise.  Open the jaws of the chuck and remove allen key.  Insert the new chuck and reverse the above procedure using loktite on chuck screw.

Leave a comment

Please note, comments must be approved before they are published

The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Your cart

×