NEW SITE SALE! Use the discount code INTRO21 at checkout for 10% your entire order! 2021/1/29 17:00:00
×
Split the machine down and remove the 2 wires at the rear of the switch (remember which colour wire goes where).  Remove the brush card and solder the replacement part onto the switch.  Install onto the rear end of the motor on reassembly making sure that the motor isn't rubbing on the brush card.  Then reassemble.  If you have any difficulties please contact us and we are only too willing to assist you.

Leave a comment

Please note, comments must be approved before they are published

The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

Your cart

×